4PCS WS2812S 6Pins 5050 RGB DC5V

Product Description

4PCS WS2812S 6Pins 5050 RGB DC5V

WS2812S 6Pins PLCC6 5050 RGB DC5V LED

6 feet built-in IC lamp beads Products:
Built-in IC lamp beads: the traditional driver IC integrated package to 5050RGB lamp beads inside, all lines are replaced by gold, not only saves space to reduce the failure rate between the pad, and shorten the transmission distance to make transmission faster more stable. . .
      The traditional full-color series of products need to drive IC needs RGB lamp beads is the most important is the need for a large number of capacitor resistors, and then use the circuit board will be a combination of electronic components, the middle of numerous lines through the hole Shen copper, numerous pads. . . Although the hands of customers is just a small finished, but it is experienced numerous procedures to complete. Sometimes there will inevitably be some of the “small flaws” is a failure rate of the problem. Built-in IC lamp beads completely solve this traditional problem. Leaping closer to the drive IC and the distance between the RGB lamp beads, easy to eliminate the majority of boss electronics engineers headache and inevitable problems will occur. . .

   6 feet built-in IC lamp beads Features:
     Intelligent reverse polarity protection, reverse power supply will not damage the IC.
     IC control circuit and LED point light source common a power supply.
     Control circuit and RGB chip integrated in a 5050 package components, constitute a complete external control pixel.
     Built-in signal shaping circuit, any one pixel after receiving the signal waveform shaping and then output to ensure that the line waveform distortion will not be accumulated.
     Built-in power-on reset and power-down reset circuit.
     Each pixel of the three primary colors can achieve 256 levels of brightness display, complete 16,777,216 colors of the true color display, scanning frequency of not less than 400Hz / s.
     Serial cascade interface, through a signal line to complete the data reception and decoding.
     Any two-point transmission distance of not more than 5 meters without adding any circuit.
     When the refresh rate of 30 frames / sec, the cascade number is not less than 1024 points.
      Data transmission speed up to 800Kbps.
      The color of light is highly consistent and cost-effective.
 
   6 feet built-in IC lamp beads Advantages:
  Built-in IC lamp brightness is higher than normal lamp bead brightness

  All RGB beads in the lamp bead have good consistency

   . Built-in drive IC performance and stability

   Anti – extrusion damage with hard plastic encapsulation

   Absolute guarantee of quality in the case of affordable products

   6 feet built-in IC lamp beads Product Composition:
WS2812S is a set of control circuit and light-emitting circuit in one of the intelligent external control LED light source. Its appearance is the same with a 5050LED lamp beads
One element is a pixel. Intra-pixel contains the intelligent digital interface data latching signal shaping amplifier drive circuit, also contains a high-precision internal
Part of the oscillator and programmable constant current control part of the effective guarantee of the pixel color of the high degree of color consistency.
Data protocol using single-line return to zero code of communication, the pixel reset after power on, DIN-side to accept the data from the controller to transmit, first of all
Sent to the 24bit data is extracted after the first pixel, the pixel data points to the internal latch, the remaining data through the internal shaping processing circuit
After amplification through the DO port to start forwarding output to the next cascade of pixels, each passing through a pixel, the signal reduced by 24bit. Pixels
Point using automatic shaping forwarding technology, making the number of cascade of the pixel from the signal transmission limit, only limited signal transmission speed requirements.
LED has a low voltage drive, environmental protection and energy saving, high brightness, large scattering angle, good consistency, ultra-low power, long life and other advantages. Will control the electricity
Circuit integrated in the LED above, the circuit becomes more simple, small size, easier to install.